DodgeTalk Forum banner

Status
Not open for further replies.
1 - 20 of 22 Posts

·
Registered
Joined
·
32,962 Posts
It looks like it's a good base to start a project car. What motor is in it?
 

·
Registered
Joined
·
395 Posts
Discussion Starter · #3 ·
Has a 225 with a hole in the side of it the size of a pepsi can.
 

·
Registered
Joined
·
395 Posts
Discussion Starter · #5 ·
I have a 318 setting in the garage. Had been looking for a car to put it in, found one.
 

·
Registered
Joined
·
32,962 Posts
That's a good reliable motor. With a few add on's you can really make them come alive!
 

·
Registered
Joined
·
395 Posts
Discussion Starter · #7 ·
Body work first, than engine work. But have plans for the engine.
 

·
Registered
Joined
·
16,621 Posts
Looks to be pretty solid. Good time for a V8 swap.
 

·
locogk
Joined
·
5,864 Posts
looks good i sold mt 73 dart about 2 years ago i miss it
 

·
Registered
Joined
·
395 Posts
Discussion Starter · #13 ·
Body has two rust spots, left floor pan rear about the size of a small plate, and pin holes in the spare tire well. Other than those not much of a rust issue. Going to take everything out of the car and repaint it inside and out.
 

·
Registered
Joined
·
395 Posts
Discussion Starter · #15 ·
Took out the seat and the bad 225. Took pictures of the floors but have not downloaded them yet. Will do so this week-end.
 

·
Registered
Joined
·
395 Posts
Discussion Starter · #18 ·
Might of been him. Will put new floors in it soon.
 

·
Registered
Joined
·
35,850 Posts
You can buy 1/4 floors for the Dusters/Darts for fairly cheap
 

Attachments

·
Registered
Joined
·
395 Posts
Discussion Starter · #20 ·
Was looking at year one floor pans. Haven't odred them yet. Where did you get yours and how was the quality?
 
1 - 20 of 22 Posts
Status
Not open for further replies.
Top