[sparky450]

New hear. I have searched and can not find it anywhere. How do I remove the stereo to install a IPOD interface? Basically how do I get the bezel off?
EDIT I forgot to add it is a Laramie Package
Thanks in advance

 

[DodgeHemi61]

Sparky, I just installed the Factory Navi/6-disc changer radio in my 07 Ram. And all you have to do to remove the complete bezle (from the sig lighter and aux power up to the top of the radio) is remove the two screws that are in the drink holder opening just below the cig lighter and the 12 volt outlet, then pull it out from the bottom. The Bezel is held in with clips on the side of it.
The radio had four screws holding it in. It is a Piece of cake with my bench seat. I have the drink holder that drops down and the two screws are just behind the upper lip in the opening.

 

[AudioNutz]

...Unless you have front buckets, then you need to remove the entire console.

 

[sparky450]

Thanks for the replies
Actually I finally found it in a thread Sunday. I did not even have the two screws by the cup holders. I just slid a spatula under the bezel at the cig lighters and pulled it off. Your right piece of cake.