DodgeTalk Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi everyone.
I have an 06 5.9 mega cab. The 4x4 light was blinking and not engaging the actuator.
I removed the actuator and and manually worked the transfer case. Until I could replace the actuator.
Today I installed the new actuator and plugged it in and still the same problem.
4x4 blinks on the dash and does not engage. Does anyone know where I go from here.
 

·
Registered
2008 Ram Bighorn
Joined
·
197 Posts
Check the wheel speed sensors, I had a bad one and it would not engage the front axle actuator.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Check the wheel speed sensors, I had a bad one and it would not engage the front axle actuator.
There is actually a code for the rear Speed sensor Up. I will get that taken care of and let you know how it goes. Thanks man I really appreciate your time.
 
1 - 3 of 3 Posts
Top