DodgeTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
Hey guys - I have an 04 Hemi D and not sure about something -

If I turn the key to "ON" and don't touch anything, the dash goes through it's normal "light up all the lights" and then after a second most go off, and then it goes "ding" once and I believe the throttle-by-wire and then I think one other light (possibly the oil change light?) stays on. I saw a service procedure once about calibrating the throttle by wire system that seemed to imply this was semi-normal...?

Lights are all off when the truck is running. Just want to verify that this is normal behavior, didn't see this mentioned in the manual and seems a little odd, but truck runs fine and nothing illuminated when it's running.
 

·
Registered
Joined
·
103 Posts
Sounds right - would have to try it to confirm. If you turn on the ignition and let the lights do their thing, you can then calibrate the throttle by pressing the accelerator pedal briskly to the floor and letting her back up.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top