Search Results for ‘vacuum’

Hi, I have a 2006 Dodge Caravan 2.4L engine that had the engine oil pump replaced. After fixing a previous issue with a flex supply jumper, my van runs ok. However on idle, the engine most likely than not, will stop. Diagnosing it with another person, turns out it has to do with the vacuum...

I need help locating a new or used (vacuum switching valve) for my 83 Dodge Ram B-150 van, the unit sets on the back firewall just below the hood and has a lot of vacuum lines going to it, I have been looking for it for over 9 months now. I have pictures of it, just don't know how to upload them...

See the check valve going into the port marked P? Ignore the red circle and arrow (I stole the image from the internet) Which direction should it allow flow? The symbol is no help and I can't find anything on the internet that helps. I'm assuming that the P is for Ported Vacuum and the M...

Three vacuum lines from the climate control unit pass through this connector into the engine compartment. They go to engine, water actuator and fan housing actuator. The connector ports are in a "V" configuration. Therefore, a top left port, bottom port and top right port. I need to know...

Short version, I burned up all of the vacuum lines, the charcoal canister and cold air intake in 87 D150 2WD Slant6 4 speed on floor no AC. I put caps and plugs on all of the intake and carb ports and the thing fires right up, but I lose power climbing a long hill at 1,800 rpm with heavy...

Hello all, I am new to the forms, but I am Warlock's Dad's Son so the Truck has been on here a few times. We recently ditched the junked and blown 318 that came with the truck and built a new 360 with a junkyard 360 Magnum block out of a 250k mile Ram. This was supposed to be a budget build...

The problem started after long distance acceleration. I've narrowed it down to the Secondary Vacuum Control Diaphragm but I'm not sure how to fix the issue. The spring on the SVCD seems to be getting stuck. I can only correct the issue by manually pressing the spring out toward the front of...

Hi, recently got a 1997 B2500 5.2L conversion van with 65K miles. I have driven it about 400 miles so far.... it seemed to start and run good with no issues but I'm not used to big cars and it was new to me. It was getting poor gas mileage, 10-11 highway and maybe 6 or 7 around town. I took it...

Hello! First time poster here, so please forgive me if I make any major mistakes about posting :) I have a 2001 ram 1500 with a 318 and 5 speed manual. We just replaced the engine about a thousand miles ago (block and both heads). The problem is that the truck idles high (about 1500 RPM) when...

I just bought a 2000 dodge durango slt and come to find out it had a blown head gasket. I bought a gasket set and replaced most of them( the ones i knew). i put it back together and come to find out i had warped valves on the driver side head so i replaced the head. Now i still have a ses light...