DodgeTalk Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-14 of 14 Results
  1. 3G Dodge RAM - Sport Truck Talk
    Hey guys new here I have a 2007 ram 1500 5.7 2wd i had some front end work done about 4 months ago and my steering has gotten horrible in the past week the shop I to said everything looked fine but his face said i took a look myself
  2. Dodge Ram Truck 3rd Gen (02 – 08) Forums
    Hey guys so I just picked up this nice 3rd gen Cummins that has very low miles and almost no rust but the steering was awful, so I replaced all ball joints and tie rods with Detroit axle parts. The steering feels better now after I had it aligned but it still wanders and I know that the steering...
  3. Dodge Ram Truck 3rd Gen (02 – 08) Forums
    I have a 2003 dodge ram 1500 4x4 I'm taking to have a 5inch lift and 22x14s and 35s put on im wondering who makes steering upgrades for these trucks I see it all the time for the 2500/3500 but not for the 1500s
  4. Dodge Ram Truck 3rd Gen (02 – 08) Forums
    Hello everyone, I'm new to this forum and Dodge Rams, I'm a fleet mechanic and I've mostly worked on Fords Anyways I have a 2008 Ram 1500 4x4 5.7L and the power steering pump pulley had broke, and I'm having a Heck of a time finding a replacement, Without going to a junk yard is there or...
  5. 2G Dodge RAM - Drivetrain Talk
    Stuck!!!!! My 00 dodge dakota is riding rough, the front end feels very unstable like the wheels are going to fall off . It started on the passenger front side . Replaced upper & lower ball joints , tie rod ends , sway bar link , control arm bushings, wheel bearing, a-frame, almost everything on...
  6. Dodge Ram Truck 1st Gen (88 - 93) Forum
    Lost power steering and brakes on steep hill under under 30mph, was back to normal after shutting off than back on. Truck was running all morning & temps dropped below 35F night before. 89 Dakota 3.9L: does power steering and brakes run off the same hydraulic circuit?
  7. Dodge Ram Truck 2nd Gen (94 – 01) Forums
    I have a 1999 1500 manual shift. It has tilt steering and the wheel has gotten very sloppy, I took it apart and found that at the pivot point for the tilt, where the column shaft meets the Steering wheel is worn out. Can the tilt head be disassembled like a GM tilt column or is it all one unit...
  8. Dodge Charger (06-10) - General Talk
    Having an intermittent issue with my daughter's SXT. She was pulling into a parking spot, and suddenly lost power steering. She went to kill the car, and after the turning the key to Off, the car was still running. After cycling the key a couple of times, it finally died. Once she restarted...
  9. Dodge Ram Truck 1st Gen (88 - 93) Forum
    my 93 w 250 has alot of play in the steering. I know I need to replace the steering shaft which is half the issue. What is a good replacement for both shaft and gear box? There are so many choices but i don't want to throw money away on what looks good. Any recommendations that are proven to...
  10. 1972-1987 Dodge Ram Trucks (D, W-series)
    Hi I was hoping you can help me on my Custom 1946 DodgeTruck Power Steering gear box. My father installed it 20 years ago and cannot remember if he got it from a 1984 Dodge D250 truck or a 1977 Diplomat when he bought the whole front suspension. What I do know: 1. There are casting numbers on...
  11. 3G Dodge RAM - General Talk
    I have taken my truck to my dealership several times, attempting to address and fix this issue. So far, I have not had any luck. Any suggestions would be appreciated. The vibration only occurs when I'm at very slow speeds and when I turn the wheel to the left or right to about 50% of it's...
  12. 2G Dodge RAM - General Talk
    Hi, I've noticed my 95 dodge ram 1500 recently started clicking noises somewhere in the front end when I steer back and forth.. Anyone know what this might be ?? Thanks
  13. Dodge Magnum - General Talk
    I have a 2005 magnum rt with rear wheel drive and I have a rocking noise in the front end when going over bumps. I put it on the lift and everything seems tight. anyone got any help what to look for?

1-14 of 14 Results