Search Results for ‘power steering’

Recently my power steering pump completely went out on my 2006 1500 5.7. I replaced it almost immediately within the next day or so, and bled the system except for the rack. After the new pump was in, about a week later I realized a leak in the oil cooler, and power steering fluid was dripping...

Im a little stuck here. I 'm 90% sure my power steering gear is bad but I would like to double check. I bought a 1990 d150 with a 5.7 Hemi swapped into it. I drove the truck home with no power steering and was told it was just a bad feed line. I replaced the feed line because it did seem to be...

Hi I'm new here in the uk I'm struggling to get a new power steering pump the output shaft seal has gone cannot find one anywhere either pump or seal if anybody can help much appreciated.

I'm having a problem with my 94 dakota power steering and rack. I'm loosing fluid from the pump but I can't find any leaks or puddles any where. What is going on with that. I've put on a new pump. How much fluid does it take?? I'm going crazy guys. Need help fast because I use it for work.

Hi! I am new to the forum but if anyone could help me find a remedy to my problem. The splines on the power steering coupler that connects the power steering gearbox to the steering column have gotten worn out. This has resulted in the steering wheel becoming useless as it free-spins without...

About a year and a half ago, I noticed a puddle of foamy power steering fluid on my driveway when it was cold. I took the truck to a shop to get it inspected and they replaced the rack and pinion and all was good until recently. Recently while on a trip, my power steering started growling and...

I've read a bunch of the previous posts about power steering/rack and pinion leaks. Where the leak appears to be coming from is shown with an arrow in the attached image. Anyone else have it from here? I cleaned up the area and the hoses. After starting the vehicle and turning the wheel a...

the dealer flashed the computor and the new flash expects to see a power steering sensor...truck doesnt have one....can someone provide the wiring diagram for the pins at the ECM so i can wire in the new switch , buy the proper hose and switch and get the engine light off .