Search Results for ‘limp mode’

My van has gone into 3rd gear limp mode. I have a bi -directional scan tool that will not get any information whatsoever from any transmission related requests. It comes back with “invalid response received” when trying to comm with TCM. Also the PCM is throwing transmission pressure codes...

I have a 2009 Dodge Grand Caravan 3.3 L with 268806 miles C/V trim, but having random limp mode issues for 5 years. No one can figure out the cause. Thunderbay Dodge could not find the issue, and Criswell Chrysler Dodge as well. Factors that seem to cause the limp mode: Ambient air above 70...

Of course i have the 2002 dodge ram 1500 5.9L gas thats stuck in 2nd gear and wont shift to 3rd and i know about the transmission shift solenoid problem so one day i was driving and it went into limp mode made it home it was low on oil and when i plugged in my scanner sure enough it was the...

Hey guys! So heres the problem... I own a 2004 Dodge Ram 1500 with the 4.7 V8 with an automatic transmission. About 3 months ago i was experiencing some problems, my check engine light would come on and if i came to a stop my truck would barley move. I found out that my truck is going into...

Hello, I am new to this forum. I have an 08 Avenger SE 2.4L. I have seen a few discussions about the ETC light coming up on the dash. This has happened to me, as well. Maybe a little over a week ago. At this point, my vehicle is not drivable.....basically. When I start it up, it turns right...

Transmission bumps then it only has 2nd and 3rd, If I pull over and cut the truck off and back on, every thing is fine. Check engine light comes on for a few days then goes off. Most of the time it will be fine for a month or so. Some times it will act up a little while later. When it does...

Hello all, I have a 2003 Dodge Stratus 2.4L SXT. I Recently replaced the Ipod cable to the back of my headunit and ended up blowing a fuse to my door locks/interior lights. Found the fuse, replaced and all was good. Went to start my car and noticed that all 4 gauges were no longer responding...