DodgeTalk Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 20 Results
  1. 1972-1987 Dodge Ram Trucks (D, W-series)
    Hey guys Im lookin for a driveshaft on a dodge 440 4speed fulltime 4wd. I have looked and looked and I can not find anything helpful. Im a kid in highschool so I was wondering what the best option for a rear driveshaft would be. I dont really care if its OEM I just need a drive shaft as this...
  2. Dodge Ram Truck 2nd Gen (94 – 01) Forums
    OK I did a full rebuild and and everything was fine ,drove for two days zero issues. Got home and parked in the garage next morning only have 1st and reverse when I go to leave .won't move in drive or second, I pulled the pan and filter everything super clean nothing dirty no burnt fluid smells...
  3. Dodge Ram Truck 2nd Gen (94 – 01) Forums
    I have my second gen dodge and i just replaced the stereo with a new aftermarket one, i got the wiring done right and it worked fine for a few days. now it won't turn on unless i move the wires a certain way and even then, it only works for a second or 2. i believe i have it located to the power...
  4. Dodge Ram Truck 3rd Gen (02 – 08) Forums
    Hello. I have a 2004 Dodge Ram 5.7 L and 2 wires of the wiring harness for my transfer case (243 D) shift motor are broken. This shift motor is strange to me because it has 2 wiring harnesses instead of 1: one with 2 wires and one with 7. Does anybody know where I could find this part? Should I...
  5. Dodge Ram Truck 3rd Gen (02 – 08) Forums
    Hey guys so I just picked up this nice 3rd gen Cummins that has very low miles and almost no rust but the steering was awful, so I replaced all ball joints and tie rods with Detroit axle parts. The steering feels better now after I had it aligned but it still wanders and I know that the steering...
  6. Dodge Ram Truck 2nd Gen (94 – 01) Forums
    hey guys i’ve got a 97 dodge ram 5.2l auto and i was wondering a couple of things. 1.which coolant should i use in this truck?? 2.which ignition coil brand should i go with?? 3.any tips to make these trucks run good and forever??? thanks
  7. Dodge Charger (06-10) - General Talk
    My charger will not charge. I have put two brand new alternators and two batteries into it. Each one tested and should be working. They work individually but the alternator does not charge my battery. Thoughts?
  8. 4G Dodge RAM - Interior/Exterior Talk
    I have been dealing with a strange noise inside my truck cab for a few months and just can’t pin down exactly what the issue is, but I don’t want to start pulling everything apart until I know exactly what the issue may be. I’m no mechanic but I’ve been fixing this truck up for around a year and...
  9. Dodge Ram Truck 3rd Gen (02 – 08) Forums
    I've managed to at least separate my driver-side axle from the knuckle with the help of a 7-ton puller, but the inside is stuck to the intermediate shaft. So far I've tried: prying from multiple angles slide hammer rotating the axle and hammering again spraying the area with wd-40 I've been...
  10. Dodge Charger (06-10) - General Talk
    Good morning Am having an issue with my tail lights. A few weeks ago I replaced One of my brake lights blub. Now I come to notice that when I turn on my tail lights at night they turn on. But once I start driving they turn off and won't turn back on. Then when I turn on the car again later they...
  11. 3G Dodge RAM - General Talk
    hello, i just got home in my 2004 Ram truck. I tried to roll up the windows after turning it off so i tried to turn it on but it wouldnt. The antitheft mode was on and i feel like ive done a lot. any tips? ive done the thing where you remove the fuze and put it back in but nothing. Only a red...
  12. 1972-1987 Dodge Ram Trucks (D, W-series)
    OK, So I am not a Mechanic by any stretch of the word, My Grandfather is tho. He is intersted in buying the vehicle in the Title, but Someone bought a R battery and hooked it up so it ended up being Pos-to-Neg & Neg-to-Pos now the Truck won't do anything with a New Correct Battery hooked up...
  13. Dodge Dakota 2nd Gen (97 - 04) Forums
    I replace the map sensor in the truck and after taking it on a very calm ride the truck stops working and the gauges stopped to where they were last on the cluster after turning the key on and off the battery fuel and other gauges only go up to the red line of the stats and the truck wont start...
  14. Dodge Ram Truck 1st Gen (88 - 93) Forum
    Hello everyone. I have a 1988 dodge w150 power ram with a 318 in it. It's the first year of the throttle body. I am having what seems to be a firing order problem. I've set the engine at tdc compression and have the firing order right. It will not run. But if I take random wires and plug them in...
  15. 4th Gen Caravan Talk (01-07)
    Aloha from Maui, I have a 2002 Caravan Automatic with the 2.4L 4cyl with low compression after a rebuild... Bought it with low compression and excessive blow by, pulled the head and found a popped head gasket between 1 and 2, with damaged #1 piston + rings. I sent the head to the machine shop...
  16. Dodge Stratus 1st Gen (95 - 00)
    Need to change spark plugs & wires and upper intake manifold has to come off. How to do take out the left side (passenger) retainer bolt? I was thinking stubby ratchet wrench but don’t have any rn. Any tips? 2000 dodge stratus es V6
  17. 3G Dodge RAM - Drivetrain Talk
    I have never actually posted to a forum and I’m not a mechanic just a guy trying to fix my truck. But long story short I was driving down the road and a clunk started at wheel speed but only going forward and it doesn’t matter if I’m turning or not. So out of instinct I lifted the rear spun the...
  18. 1972-1987 Dodge Ram Trucks (D, W-series)
    Behind the seat tank.... 74 d100 ... Finally got a sending unit for it.... probably a bad idea with the dual carb 511 stroker thats propelling the ol thing but what the hey.... lmao... nothing like visually watching the fuel hand tank in seconds 🤣🤣 Got it from vans auto... part number CHTSND002...
  19. Product Reviews
    I've had Vera since new in '87, she's a little dented but I love her. I've got about 435,000 miles on her 6 cylinder and am on my 3rd clutch in the 3SPD with OD. I really do not want a car payment so I am going to save about 6 months of what would be a $70,000 truck payment to do some work on...
  20. DodgeTalk New Member Welcome
    I need to remove the bed of the truck Ram 3500. Diesel Any advices And if I will go to a body shop, Anyone knows how much it could cost ?
1-20 of 20 Results
Top