DodgeTalk Forum banner
Status
Not open for further replies.

M1 Ready to Install

876 views 7 replies 6 participants last post by  UNHPistol 
#1 ·
Just picked up the M1 from the powder coating shop on Friday and I decided to share some pictures.







It took a while, but I finally found a local shop to coat the M1 for a reasonable $75

I was going to save the M1 until I had the 390 built, but I think I'll have to toss it on now.

The throttle body is a 50mm F&B that I took off my truck for the photo op.

The M1 is gasket matched and ready to go :SPIN:
 
See less See more
3
#5 ·
I'll post pictures after the install. I'm working on the fuel rails now, removing the end plugs and brazing in AN fittings so I can have front and rear stainless hose crossovers.

When I install the M1 I'll be routing the fuel injector wires and vacuum lines through the M1 to try to clean up the engine bay.
 
#6 ·
they did a great job on it........... TB is a nice chunk of billet........ like one myself
 
#7 ·
Looks really good! Are you going to a 52mm or 53mm tb with the 390?
LOL, seeing everyones posting intakes, Ill have to post a couple of my new one :)
 
#8 ·
I'll definitely be upgrading to a 52mm or 53mm for the 390, and if I get really lucky I'll find someone that wants to trade throttle bodies.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top