DodgeTalk Forum banner
Status
Not open for further replies.

Help with DPDT switch PLEASE

426 views 1 reply 2 participants last post by  Wayne Lemieux 
#1 ·
Hey guys, I've got a lightbar mounted on my ram and I'm having some confusion on how to wire it up. I'm wanting to be able to power th lightbar on two different ways. With a on/off/on switch.
Position 1-On with switched battery power
Position 2- Only on when high beams are switched on
I ordered a DPDT switch after reading quite a few forums. I'm very confused on how to wire this switch.. Most are wired with one input and two outputs, but for this I would need it to be two inputs and one output, correct? A diagram or something would be greatly appreciated.
Sorry if I'm way over my head here guys :dev
 
#2 ·
battery power is not a problem to find and hook up to one side of the relay the other has to be the output from the light relay some where under hood or find the high beem wires for both lights and tap into themand join them to have a single wire to the other side of the relay for pin numbers i`not sure 2 and 4. then the other side to the lights. do not forget to fuse befor the relay. think of it as two different relays to control one output
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top