DodgeTalk Forum banner
Status
Not open for further replies.

Correct rotor and hub assembly for non-abs '79 b3500?

578 views 2 replies 3 participants last post by  van-nut 
#1 ·
It is time to replace my front brakes and figured bearings as well, but I am quite confused as to the part number I should purchase. I've read a few threads here and have seen cases where the bearings don't fit the rotors so I want to make sure I have correct part numbers.

Details of my van:

1997 B3500
Non-ABS (I think), codes from under hood sticker:
BGJ _ POWER BRAKES - FRT DISC/RR
DJD - 3600 FRONT AXLE

From the mopar part manual this looks like Mopar 04086830 for the hub and rotor assembly.

The number of combinations is quite large and it looks like in some cases this can be an issue. Would someone mind posting a link to rockauto or other store of hub/rotor assembly that fits the specs above?

Thank you!
 
#3 ·
If you want Mopar parts, call the dealer and give him your VIN and he should be able to tell you the correct P/N.

If you have front ABS, there should be sensor wires clipped on to the front brake hoses. Crawl under and take a look. I'm not certain on the '97's, but for '98 rear only ABS was standard and 4 wheel ABS was optional.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top