The screw into four corners of the block, and you can clip the gasket and pan into them. A set was included when I did my sister's Sable. They made the job a whole lot easier because the pan and gasket stay in alignment 1/2" from the gasket surface.
when i replaced my oil pump(2x) the gasket was stuck to the block both times....you can use gasket-cinch....it will hold the gasket in place for u....guess i was lucky....no leaks up to this point......
Status
Not open for further replies.
You have insufficient privileges to reply here.
Related Threads
?
?
?
?
?
DodgeTalk Forum
4.7M posts
290.1K members
Since 2002
A forum community dedicated to all Dodge owners and enthusiasts. Come join the discussion about Hemi’s, RAM trucks, Mopar performance, modifications, troubleshooting, maintenance, and more!