DodgeTalk Forum banner
Status
Not open for further replies.

Transmission(engine) removal 4.7 -45RE

8K views 4 replies 3 participants last post by  !05RAM05! 
#1 ·
Hello, I am actually in the process of changing motors, sludge got this one, and I am stumped as to how to get to the upper most bolts on the bell housing. There does not seem to be enough room to get to the upper 4 bolts. Any advice would be appreciated. Thanks
 
#2 ·
Usually ,you let the transmission hang down (with the crossmember removed) and you can get to them with a 36 inch long 1/2 extension.
 
  • Like
Reactions: ECONORAM
#4 ·
You shouldn't have to.
 
#5 ·
but you will eventually
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top