DodgeTalk Forum banner
Status
Not open for further replies.

v10 crank position sensor

6K views 5 replies 2 participants last post by  vaquerorngr 
#1 ·
can anybody tell me how to get the crank position sensor out of the side of a v10 block, please?
 
#2 ·
Probably takes a bit of twisting, maybe some prying if you can get a screwdriver or something in there. They usually have a little o-ring on them that sometimes gets hard and doesn't like to slide well. They also get oil varnish build up on them that has to basically scrape off on it's way back out through the block. Be careful not to break the head off the sensor though, or you will really have fun getting it out :)
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top