Getting all the measurements taken, and figuring out routing paths as well as mounting points so I could make some orders.
Rancho 9000 shocks
Air lift rear helper springs with 25572 system
Test fit the SRT 10 calipers and rotors UNFORTUNATELY I can't use the stock 17s with the SRT set-up, and I can't use my 20s because of my dr's. So I have to get a new set of 20's with some all season tires before the new front brake set-up goes on.
The new rear rotor's are on (double drilled/slotted), and the new bushings are all on for the steering rack, and sway bars, as well as new sway bar end links and new ball joints.
Yeah, any 20" wheel would fit over the brakes. The stock rotors are 13.2" with the Caliper hatted about 2" over. The stock SRT rotors are 15" with the Caliper seated about 2.5" over being to large for the inside of the 17 by quite a bit.
My plan is to run the Ranchos on 9, in combination with the helper springs in the rear, with all the suspension odds/ends replaced. If I can make it to where the D doesn't sway, or bounce, than the D is going to some road courses next year.
20" wont fit i hear. The guy who had my SRT rims had some 20's and after he shipped mine he found out they didnt fit.
Status
Not open for further replies.
You have insufficient privileges to reply here.
Related Threads
?
?
?
?
?
DodgeTalk Forum
4.7M posts
290.1K members
Since 2002
A forum community dedicated to all Dodge owners and enthusiasts. Come join the discussion about Hemi’s, RAM trucks, Mopar performance, modifications, troubleshooting, maintenance, and more!