DodgeTalk Forum banner
Status
Not open for further replies.

difference between 5.2 and 5.9

8K views 6 replies 4 participants last post by  360sst 
#1 ·
i was wondering is there any way to tell the difference in a 5.2 and a 5.9. the reason i ask is i want to buy a short block 5.9 and im worried they might just be sending me a 5.2 block and id never know the difference. im considerding buying the short block to build on instead of rebuilding the 5.9 i have and then buying mods such as heads i think the short block would be cheaper. what do u think ?

here the link to the motor that i found

http://cgi.ebay.com/ebaymotors/CHRY...trksidZp3286Q2em20Q2el1116QQitemZ130248860049
 
#2 ·
#3 ·
The 5.9 Magnum has a 4.00" bore and 3.58" stroke . The 5.2 Magnum has a 3.91" bore and 3.31" stroke. :gr_patrio
 
#4 ·
im 85% sure my 360 says 360 on the drivers side of the block. ill check after school tomorrow for ya.
 
#6 ·
it can, i just looked. on the drivers side of the block there are some number's and at the end say -360. ex. xxxxxxxxxx-360
 
#7 ·
thanks guys
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top