overheating problem [Archive] - Dodge Talk Community Forum


Click Here to Visit The Planets Largest Dodge Enthusiast Community




PDA

View Full Version Of This Page : overheating problem


My Beast
04-07-2006, 05:25 PM
ok i done every thing that i know to fix the over heating problem, ive change the thermistae housing twice the thermisate 3 times the hoses the radiator the raditaor cap and now the coolant temp sensor. what else could calse it to overheat. the head gasket is good the water pump i only a year and a half old. please help. thank you.

Mopar Ernie
04-07-2006, 08:49 PM
:gr_patrio Radiator? How many miles and what does the antifreeze look like?
:drivingz:

rice_eater
04-07-2006, 10:57 PM
completely flush the radiator and engine block, then refill with a 50/50 mix.

My Beast
04-08-2006, 08:34 PM
its green like it should be i dont understand y it is doing this.

rice_eater
04-08-2006, 10:40 PM
It may look green in the radiator, but you dont know if a coolant channel is clogged in the block or elsewhere, limiting coolant flow.

Mopar Ernie
04-08-2006, 10:46 PM
completely flush the radiator and engine block, then refill with a 50/50 mix.

This is your answer!

:drivingz:

xboxizdope
04-09-2006, 02:34 AM
I'm no car expert but I'd say definitely go for a radiator flush. My last car was running perfectly fine up until the night I had a friend test drive it to buy it off me, that was the night I found out the radiator fluid was completely dried out and caused it to over heat. It was really weird because it was running great and out of no where started overheating, but it was because I didn't flush the fluid (or even check it really). Long story short she still bought the car but had to replace the radiator.

From just looking in the reservoir it looked fine, but it was all dried up n gunked up under the radiator cap. I'd suspect if it hasn't been changed it could have dried up in other parts as well, so I'd flush that out since it's pretty easy.

My Beast
04-09-2006, 11:19 AM
ok ill try that.

TX_Firehawk
04-09-2006, 12:34 PM
Yar beast, most shops have a machine they hook up into the cooling loop and add some pressure along with some cleaning solution (or something, cant remember what it was we use to pump through them but it was a Wynns machine) and it will clean out the passages better than we can @ home. Cost was like 60 bucks.



One idea also- is your fan kicking on? If the fan is broke you will overheat. Don't ask how I know! :thatfunny

Good luck.

My Beast
04-10-2006, 09:06 PM
so far so good