Speed Dragon
01-08-2006, 09:18 AM
Got the hydraulic clutch line and master and slave cylinders and reservoir installed yesterday. Seems to be working, don't have the wiring plugged up or the coil put back on yet (it was used to start an old van of my Dad's), so I couldn't crank it, but I can hear the clutch moving, and I pushed the clutch in and cracked the bleed screw, and it's got plenty of pressure in it and the pedal feels pretty firm.
Also did a little more work on my customized gauge panel, got the stock holes reamed out for aftermarket gauges. So hopefully I'll have it running in the next week or so. Still need to put a rear seal in the trans, drill the mounting pad to fit the stock trans mount, block off the heat choke hole, re-install the coil and coil wire, and put a gas tank in it.
Also did a little more work on my customized gauge panel, got the stock holes reamed out for aftermarket gauges. So hopefully I'll have it running in the next week or so. Still need to put a rear seal in the trans, drill the mounting pad to fit the stock trans mount, block off the heat choke hole, re-install the coil and coil wire, and put a gas tank in it.