My rear wiper, rear washer, recirculate and a/c button lights are flashing all the time. In sync. Sorta cute, actually, but driving me nuts!
Any ideas?
Thanks,
Bill
vipergg
12-23-2005, 07:23 PM
This has happened either because you disconnected the battery or the battery is getting really weak or you have dirty cable connections on the battery. To reset follow below.
With engine on set blower motor to high, set mode position knob to panel (i.e. full left), open all A/C outlets, set temperature to cold (both levers if so equipped). Now press the wash and rear wiper buttons on the A/C panel simultaneously for 5 seconds (until all LED's light). This should get the test started. Assorted lights on this panel will flash as different tests are run. Eventually if the tests are passed the rear wiper LED should be the only light flashing. Push the rear wiper button to exit test mode and you should be home free.
donald7150
12-23-2005, 07:46 PM
this should solve your problem the above procedure initiates the cooldown test/calibration, make sure the A/C has been off for a while and the outside temperature is warm because if the evaporator is already cold the test will fail and you will be back to the blinking lights, I will include a complete rundown of all the procedures in a PDF file
Bill Viverette
12-30-2005, 02:40 PM
Wow...just that easy! I really appreciate the good advice from both of you.
