i have a 79 pw and i am raplacing the driverside bearings but i think a few things are not the way they should be, could someone please give me a list of parts that should be there from the steering knuckle out.
Chump
12-19-2005, 09:10 PM
Is this a fulltime 4 wheel drive and do you have the Dana 44 front axle setup?
http://ramchargercentral.com/index.php?action=howtoshow;id=35
Rayven
12-20-2005, 06:40 PM
yes its the full time 4x4 spicer 44 fbj
Chump
12-20-2005, 08:32 PM
yes its the full time 4x4 spicer 44 fbj
Does this help any? Same setup is used on the full time 79 axle. Also might want to look here...
Front Drive Axle (http://autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/1a/6a/f9/0900823d801a6af9.jsp)
Paul McCoy
01-06-2006, 06:09 PM
Do you have the part names that go with the numbers?...Thanks!
Chump
01-07-2006, 02:04 AM
Do you have the part names that go with the numbers?...Thanks!
Picky...picky :)
Paul McCoy
01-08-2006, 01:05 PM
Thanks Chump.............I'd rather be picky than sorry! Since some of the parts were destroyed when one of the bearings came apart, I wasn't sure of what went where and what it was called.
Chump
01-08-2006, 03:06 PM
Paul, if you need more help with your project, just ley me know. I have been diddling with those bearings/rotors since 1977.
Paul McCoy
01-09-2006, 05:27 PM
Thanks Chump......I am removing the rotor assembly from the other side of the truck next, to see how things are assembled. The driver's side must have dried up and caused the outer bearing to go south. I am almost certain I will need to replace the rotor/hub as the loose bearing rollers did a number in the area where I think an outer seal goes. I will probably have more questions for you as things progress.
