Outter Tie-Rods (What's the correct wrench size?) [Archive] - Dodge Talk Community Forum


Click Here to Visit The Planets Largest Dodge Enthusiast Community



PDA

View Full Version Of This Page : Outter Tie-Rods (What's the correct wrench size?)

zytariuk
07-25-2005, 10:14 PM
Im' trying to get the jam nut off the outter-tie rod, are these nuts in metric or imperial? Any ideas on how to get this sucker off, it's sooooooooooo seized on their it isn't even funny.
six pak
07-26-2005, 07:24 PM
You could try a 5lb. if that fails there is always the SMOKE WRENCH after all you are replacing it arent you?