I am installing a Kenwood XXV-05V head unit which has the separate hide away box. The factory system does not appear to be an infinity system as it is not labeled as such. I have everything hooked up, I have triple checked the wiring, and for some reason I have no audio. Everything installed works fine except for the audio. Does anyone know how I can tell if there is a factory amp that i need to run power to? Where would it be located? Any help is appreciated, I want to get this figured out so I can put my dash back together.
DGC96
08-11-2009, 12:48 PM
make sure that u hooked up the blue amp wire from the kenwood radio to the blue wire from the wire kit labled amp or remote... also make sure that the ground cable is in a good place. there migth of been another wire hooked up to the ground n migth of forgotten to connected...
hope this was helpful some what
BrianS
08-11-2009, 08:23 PM
You need to power the relay in the fusebox. Check here for more info:Amp Relay (http://wiki.answers.com/Q/Where_is_the_Amp_Relay_on_a_2001_Chrysler_Town_Cou ntry)
