How to install Bi-xenon (9007) on Caravan 2002?

[mlacau]

Hi everyone, this is my first post. I have a grand caravan sport 2002, with 168.000 km, and she's running very good.

I bought this kit(Bi-xenon Bangho), (he comes with wires, ballast,relay, etc, etc.), I installed, and after that, the low-beams are ok, but the high-beam dosen't work.

Any ideas? I plug this, only to the driver side, to take control of the ligths.

[StandOnCliff]

If low beam and high beam worked before installing this kit,I would say it isn't installed correctly.
As for how to wire it,I don't know as I don't install aftermarket lighting solutions.
If I did though,I would look into checking out the manufacturers website of the kit for a solution.
The best thing I could do for you is to give you a picture of the wiring diagram for the headlights.

[mlacau]

If I go back, and change the beams, everithing is ok. The Ecu check if both beams are pluged?

[StandOnCliff]

I'm not sure. I do know that on high beam it would light the high beam indicator in the cluster. If it isn't wired correctly the high beams and the high beam indicator are somewhat integrated and may not work correctly.
Are you jumping into the connections right at the light or at the high beam low beam switch?

[mlacau]

After viewing the wiring diagram, I think thats my problem. I'm going to check if both connections are ok. Thanks !