Sunsetsabunch
01-11-2008, 04:41 PM
Hi I have searched but didnt find a problem like mine.
I have a 96 Caravan with 75k miles 3.8 eng.
I am using a Innova CanOBD2 reader.
I have been having a problem with the engine stalling... maybe when I pull up to a light... go to give it gas and notice its died... restarts no problem ... or driving down the road it just dies and as long as it is above 30mph it will restart itself or I put it in nuetral and restart.
I had an error of PO106 Map sensor and replaced that and that took care of that code.
But now I am trying to get it emission tested and before I can complete a drive cycle with only the EVAP monitor to complete it will stall and all the rest of the emission readiness EVAP, Catalyst, EGR, and Oxygen heater monitors go back to the not complete state. So of course with all the info gone ... No DTC's I am at a loss.
Anybody hear of a problem like that ????
I sure could use some help !!!!
Bob
I have a 96 Caravan with 75k miles 3.8 eng.
I am using a Innova CanOBD2 reader.
I have been having a problem with the engine stalling... maybe when I pull up to a light... go to give it gas and notice its died... restarts no problem ... or driving down the road it just dies and as long as it is above 30mph it will restart itself or I put it in nuetral and restart.
I had an error of PO106 Map sensor and replaced that and that took care of that code.
But now I am trying to get it emission tested and before I can complete a drive cycle with only the EVAP monitor to complete it will stall and all the rest of the emission readiness EVAP, Catalyst, EGR, and Oxygen heater monitors go back to the not complete state. So of course with all the info gone ... No DTC's I am at a loss.
Anybody hear of a problem like that ????
I sure could use some help !!!!
Bob