2000 GC pulls while throddling ??

[mowerman1193]

Last few times I drove my wifes GC something has felt wierd with the front end but I never could figure it out..Last night going down a new stretch of high way I noticed I was going a little over the speed limit so I let of the gas and the front end felt as though it shifted over some..So I hit the gas some and noticed it pulled to the right and when I let off again it felt like it shifted over again..Almost like the whole front end was loose and twisting a little..

The van is a 2000 with the 3.3 flex fuel..it has 105500 miles on it..Had new struts and shocks and the right outer tie rod replace at around 90000 + or - 1000-2000 miles I would guess..

Anyone have any ideas? I think I have heard in the past that a worn cv shaft would do this..I have never notice the clicking sound that the cv joints make while turning..

I plan to get some new tires for the front and the front alined within the next 3-4 weeks..So maybe they will find something then..

Thanks for any advice or ideas for this problem,

[TomQuick]

I'm not sure that a CV shaft would cause this. Perhaps control arm bushings, motor mounts, or wheel bearings, would be a good place to look.

[RickMN]

Definitely check the motor mounts and engine cradle bolts before you move on to control arm bushings or wheel bearings.