:help: ok so i got my 3" downpipe w/ electric cutout put on the other day. however, i'm having a bit of trouble figuring out where i can route the wires to get them into the cab of my car. the instructions say to route them over the axle and up the torque arm. however once i get up the torque arm i can't figure out where to go. i.e. theres no gap i can see to get it into the car
it also says to route it through the drain plug and through the shifter but it says to cut a hole in the boot which i refuse to do and also i dont see how to do that either.. please help!
elchicoyes
10-07-2007, 06:49 PM
Lol! I couldn't figure it out either. So I just drilled a small whole up to the cab from the cut out.
Dodgeneonfan
10-08-2007, 01:00 AM
yeah thats what im going to end up doing i think. man that sucks but thanks anyways.
turboneon04
10-08-2007, 01:43 PM
go through the steering colum boot.
Dodgeneonfan
10-08-2007, 11:16 PM
lol already drilled the hole. oh well.
elchicoyes
10-09-2007, 02:31 AM
Yeah, take some rubber cement or something to plug it to keep the elements from finding a way through the hole. lol! I had to do the same.
Dodgeneonfan
10-09-2007, 11:22 PM
cool thanks. i was wondering what i was going to do with that lol
Dodgeneonfan
10-12-2007, 02:58 AM
hey elchico, just outts pure curiousity, where did you drill your hole?
elchicoyes
10-15-2007, 12:42 AM
Directly above the Cut out. The hole ended up being right underneath the Shifter Bracket.
