How to wire through Grand Caravan firewall?? [Archive] - Dodge Talk Community Forum


Click Here to Visit The Planets Largest Dodge Enthusiast Community




PDA

View Full Version Of This Page : How to wire through Grand Caravan firewall??


billy1776
08-22-2007, 09:13 AM
Does anyone know or have advice for fishing wire through the firewall of an 06 Grand Caravan? I am trying to get a power wire from the battery to the interior.

Thanks in advance. -Bill

:gr_patrio

Rick99
08-22-2007, 11:09 AM
You can look for a rubber boot around something like the parking brake cable, pierce the boot and push the wire through. Alternatively, find a spot where nothing is in the way (check both sides carefully), drill a hole and install a rubber grommet to protect the wire.

Rick99
08-22-2007, 11:11 AM
One more thing-- you can get better access to the firewall on the engine side by removing the wiper motor/vent module. (the big plastic part that has the wipers attached to it.) This takes about 5-10 minutes and saves a lot of headaches. Also makes it easy to change the rear spark plugs.

javazqu
08-22-2007, 12:13 PM
Look at the firewall on the top far right. You should see the area where the hood release cable is located. I punched a hole in the grommet surrounding the cable and was able to run an 8 gauge wire into the passenger compartment.

billy1776
08-22-2007, 03:56 PM
Thanks for the replies, guys