My Avenger Aftermarket Parts Wishlist [Archive] - Dodge Talk Community Forum


Click Here to Visit The Planets Largest Dodge Enthusiast Community




PDA

View Full Version Of This Page : My Avenger Aftermarket Parts Wishlist


Snatcherchief30
04-21-2007, 09:25 PM
Ok here is my aftermarket parts wish list for my 2008 R/T:

1. Rear fascier add-on that was on the concept:
http://www.autoblog.com/media/2006/09/rearendsketch.jpg
http://www.blogsmithmedia.com/www.autoblog.com/media/2006/09/avengerstock00026.jpg
2. Louder, muscular sounding exhaust system
3. Super Charger???? Please someone make one.

ECONORAM
05-20-2007, 08:53 PM
I'd like a real sport tuned suspension, front and rear anti-sway bars (don't know that DCX has it down...), and a front upper strut tie bar. Maybe some hard rubber bushings, but not poly...

Snatcherchief30
05-26-2007, 07:10 PM
yea I would like to lower the car about an inch all around to get a better look, too much wheelwell gap with 18" wheels :YO:

Eibach actual has a kit for the '07 Sebring but I haven't seen it anywhere online other than there site and there is no price listed.

ECONORAM
06-01-2007, 08:53 AM
AFter looking at the factory exhaust manifold, my next wishlist item is a replacement manifold for the 4 cyl that is just like the early VW Rabbit/GTI manifolds, with two outlets, and the first two Ys of a Tri-Y header set-up. With a good dual downpipe, this was worth 10-15hp on the 1.8L engines... I think TectonicsTuning in OR still sells them (too bad the VW parts won't fit this engine).
The factory manifold sucks rocks. I can't believe this car is getting 30-32 mpg on the highway with that WWII era piece back there.
[EDIT] I'd also like some replacement door panels that don't have the knee-joint slicing plastic...perhaps a 1 inch cushion with the factory material covering it, or angle the plastic to better match the angle your leg is at when you are driving... And something better on the center console to prevent shin muscle damage...