i have a 99 neon 2.0, just had the pcm repaired, new ignition coil, and new crankshaft sensor. but the darn thing wont start. the crankshaft sensor is not recieving signal from the pcm. i've run out of brain power. please help.
dodgeneonACR98
01-24-2007, 01:55 PM
Did you check your wires from the crank sensor to the pcm?
What made you get the pcm repaired in the first place? What did the car do that made you think it was in need of repair? I could be wrong but it would seem to me that the problem is one of four things. Wires,pcm,sensor or harness. It's not every day that a pcm goes bad. sensors however do go bad and i hear alot of people complain about the sensors and things they buy at Autozone. I have never had any trouble with them personaly but some people go thru 2-3-4 parts b4 getting a good one! I did a few price checks one day for some type of sensor one time and would you honestly beleive that Advanced Auto actually wanted more for the part than the Dodge Garage!!!! Soooo I swindled them down to the same price as the Dodge one and got it......only becouse I needed it now and Dodge had to order one! Go figure. Another time I priced a TPS sensor at Dodge $112. Napa autoparts wanted 110. May as well buy Genuine Mopar if thats all the diff is.
I don't know if that was any help but I tried. Good Luck!!! And welcome to DT
EZ4U2CHere
01-24-2007, 03:21 PM
the crankshaft sensor is not recieving signal from the pcm. i've run out of brain power. please help.
Why are you saying this? You must be getting a code?
And what do you mean you had the PCM repaired? How exactly do you repair one?
