Does anyone know if the rear axles on the Daks with the 9.25'' diff and Rams are the same? If so, would it be possible to use lift blocks for a Ram on a Dak? I'm thinking that pairing some rear lift blocks for a Ram with the 2'' level lift available for the front would result in a 2'' all around lift.
AdidasCJ
01-02-2007, 10:18 AM
Shoot, As far as the rear ends in the dak and ram being the same i have no clue. But as far as adding 2in inthe rear and the 2in front spacer will bring you back to were your truck sits now. The two in front leveling kit is made to level the truck out and take the rake out of it. It just brings the front end up to match the rear. Now if you add the 2in blocks in the back, your putting the rake back into it. Fallow Me?
I did the leveling kit and it did bring the front level with the rear. And i have a nice level truck
lownslowneon
01-02-2007, 11:58 AM
Shoot, As far as the rear ends in the dak and ram being the same i have no clue. But as far as adding 2in inthe rear and the 2in front spacer will bring you back to were your truck sits now. The two in front leveling kit is made to level the truck out and take the rake out of it. It just brings the front end up to match the rear. Now if you add the 2in blocks in the back, your putting the rake back into it. Fallow Me?
I did the leveling kit and it did bring the front level with the rear. And i have a nice level truck
Exactly what I was going to say.
shooterschmidty
01-03-2007, 10:27 AM
yea i understand that this setup would preserve the origional rake but I think that maybe I'd rather have the extra two inches clearance to try to protect the gas tank hanging below the frame in the rear. Plus it would probably minimize the impact to gas milage since it would maintain the same angle of attack.
