On a 94 Dodge Van (Panel Van) had to replace a fuse to get the brake lights to work, and to get the hazards to work. But still not getting the turn signals to work. The fuses all look good, the bulds are fine. Question is do the hazards and turn signals work on the same fuse and relay or different ones, and could anybody suggest what I check or try next.
Does any one know where I can find a diagram of the relay and flasher module. The diagram I found for the fuse block does not show this.
Thanks
DANVAN
10-25-2006, 08:08 PM
theres a flasher relay, I think its in the near the fuse box, on my 92 I have to remove the glove box liner to access it, its a small round thing with either 2 or 3 prongs on it
Dodgevanman
10-26-2006, 06:59 AM
As Dan said, the flasher could be bad. They're cheap so popping a new one in won't be a big deal. Remove the glove box liner and the flashers are behind the fuse block.
The flasher should look like this:
stev
10-28-2006, 10:21 AM
If the Ram Van is a Gen-2 style, the the flasher and fuses are in the Dash on the drivers side between the drivers door and the side of dash.
1994 was a strange year for the transistion.
wendi
10-28-2006, 11:10 PM
Thanks for all the info.
There are actually two flashers, one for the hazards and one for the turn signal, they are located under the glove box liner, and for some reason my turn signal one has went missing, but I got a new one and they work great now. Thanks again for all the help.
Dodgevanman
10-30-2006, 07:22 AM
I think it was the "Signal Flasher Gnomes" that took it.
