Various Things and help needed

[hcmq]

First off hello everyone!

2002 GC EX 3.8

Needed help:
Can't find the PCV and no one lists a part# for it.
Can't find any real help on fixing the non-opening power rear hatch
Can't find any real help on fixing the intermittant power sliding passanger door

Various things:
If you need help I have replaced:
Fuel Filter
front sway bar busings and ends
Drivers side window motor/regulator
Front brakes

I am about to change:
the plugs
PCV
Fix the doors
Fix the "Small leak detected" in the evap system
Take the van in for the tranny before the warranty runs out

TIA

H-

[hcmq]

WOW! I'm shocked. 38 views and not one answer.

I really could use some help.

[webbee]

Chilton's shows both 3.3/3.8 in the rear valve cover and it looks to screw in from the picture. It could pull out, too. There also seems to be a hose that runs from the front valve cover to the air filter housing and is labeled a fresh air hose, as part of the PCV system on the 02. I guess I would get the replacement from the $tealer as then I would be sure it was correct. My 99 3.3 replacement looks to slip in and isn't threaded. I got it from Advance so it may not be right (Purolator PV761). I am about to do that job myself. I think the best way to do it is to remove the wiper tray/etc and then it would make getting to the rear head much easier. You should be able to do the plugs, valve cover gaskets and PCV with it off. If I remove that part to do mine I may do a lot of the under-tray parts.

The other door/hatch problems I haven't encountered. Chilton's and the Hayne's manual I have are of no help. I would/will spend the money for the factory shop manual as I think it's better than either/both of what I have. If your local library has Motor's the info might be in there.