What size are the bolts that hold the rear sway bar up against the frame? I'm talking about the ones that go through those C-shaped brackets with a rubber "cushion" for the bar and screw into a nut welded inside the frame rail. Nothing i have tried will fit. The nut appears to be fine thread, but i'm not sure. If someone with a rear sway bar would be kind enough to pull out one of the bolts and tell me what size i need, I would GREATLY appreciate it. Thanks.
DodgeNeonES
04-23-2006, 09:31 PM
ill see if i can do that for you but im not sure
rice_eater
04-24-2006, 04:23 PM
Do you have a 1st Gen? I need someone with a 1st Gen... come on guys, its not that hard!!!!! just drop the bolt, check the size, put it back in, and let me know! LOL
rice_eater
04-25-2006, 11:16 PM
Come on guys, ACR98, EZ4U2CHERE, Radar.... I know you guys have 1st Gens, and I know you have rear swaybars... I just need to know what size bolt it is. I'm guessing 9mm finethread? anybody know?????? :help:
DodgeNeonES
04-27-2006, 04:45 PM
srry i have a second gen so no help from me
rice_eater
04-27-2006, 08:57 PM
Thanks anyway.
How bout the rest of you??? why are you avoiding this thread ACR98!!!!!!! LOL
dodgeneonACR98
04-28-2006, 03:45 AM
LOL Im not avoiding it Rice! I never thought of doing that. Lmao. If I get time I will get up in there and see what I can find. Didn't Ez just do one on his car??????? Maybe you should try to get a private message to him or Radar on the subject. Im not sure I will get the time this week Im going to be pretty busy fri and I will be camping (i hope) on sat-sun. Well anyhow if nothing happens and I feel Froggy I will tear into it. later
95moparracer
04-28-2006, 01:51 PM
lol id look for u rice but i dont have one yet lol
rice_eater
04-29-2006, 10:21 PM
lol id look for u rice but i dont have one yet lol
You'll want to know too then, so you dont spend 3 hrs looking for a bolt to install a sway bar that should take 10 minutes, LOL.
rice_eater
05-17-2006, 10:46 PM
Well, I found the correct bolt size. Turns out it was a 10mm. 10mmX1.50X50.00 The problem was the threads were caked with 9 years worth of dust and dirt thrown up by the tires. I had to have the holes tapped, but after that it all went in smooth as butter. HUGE HANDLING IMPROVEMENT!!!!!!!!!!!!! I'm posting a separate thread on the topic.
